I don.t know about that I have a 71 waggy and the brackets that hold the seat in totatly capture the seat pin. where as the 74 and later you can move and slide the seat out of the bracket . Also there is an indent on the floor of the 71 where the bottom of the seat res ts and rusts if water gets in there.
I believe if you put all the parts from the later seat including the brackets on the front of the rear floor drop and the seat, it should work. As far as the fron goes you will have to drill holes maybe look underneath as the Supers had buckets and the nuts may be there already. If not you must tack some thick washers or something so you are just not using the sheet metal to hold the seat in.
Last edited by newtojeeps : 10-16-2009 at 09:11 AM.