International Full Size Jeep Association
Home Forums Reader's Rigs Tech Library Trail Stories FSJ-List
International Full Size Jeep Association  

Go Back   International Full Size Jeep Association > Tire Kickin' > General FSJ Tech

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 12-08-2007, 09:49 AM
Dmntxn77's Avatar
Dmntxn77 Dmntxn77 is offline
Hey watch this...
 
Join Date: Nov 19, 2004
Location: Gig Harbor, WA
Posts: 8,327
First engine removal...

I did all that work to get the 1 tons under the Chief, and now I have decided to swap them under my newly aquired 75 Chief..

I want to keep the T-18 also, so I decide to pull the engine/tranny/case all together..

It took me just over 5 hours from start to finish. I can probably shave of about 2 hours if I ever do it again the same way... My learning curve was a bit slow at times..

Here is what came off first..


Striped down..



The shifter on the tranny made it impossible to get the combo out with the short chain that came with my hoist. I had to use another chain to gain a few extra inches. It didnt fit that good, but it was secure..


Here is how it sits now...


Anyone need a motor? Its in the sale section...


AND.. It turns out, my new trailer makes a heck of a work table..

Last edited by Dmntxn77 : 12-08-2007 at 09:53 AM.
Reply With Quote
 


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -6. The time now is 06:32 PM.


Powered by vBulletin Version 3.5.4
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.
corner corner