View Single Post
  #14  
Old 03-02-2021, 07:28 PM
posulli88's Avatar
posulli88 posulli88 is offline
258 I6
 
Join Date: Dec 18, 2016
Location: Denver, CO
Posts: 322
ok putting the exhaust back together so I can take it to the shop and have permanent exhaust put in. Is this how the driver connection to the manifold suppose to be?

The problem is the flange doesn't clear the manifold flange so I think its stopping it from fully sealing. The height on the edge of the flange is about an 1/8" taller than the pipe which makes me think its not going to seal up.




should I flip the flange like this:



Or do I need to use a donut in between this instead?


Thanks!
__________________
77' J10 w/ 360, T18, Dana 20 TC

Last edited by posulli88 : 03-02-2021 at 08:51 PM.
Reply With Quote