View Single Post
  #1  
Old 03-29-2012, 10:13 PM
caionneach's Avatar
caionneach caionneach is offline
350 Buick
 
Join Date: Aug 19, 2003
Location: Monroe, Louisiana
Posts: 1,022
U-joint yoke & driveshaft question

I have the possibility looming before me of the necessity to switch out transmissions and transfer cases if my stock transmission has internal problems.

My rig is a 82 Cherokee with 258 six cylinder engine, T5 manual 5 speed, NP208 transfer case.

If my transmission is bad, & I'm pulling it tomorrow and will then know, I may opt to install the NP435 & NP205 I have. My question is about the yokes & u-joints from the transfer case to the axles, as the yoke on the NP205 appears to be a good bit beefier than the stock yokes on the Jeep axles.

I am under the impression that the Jeep yokes/u-joints are known as 1310, and those on the NP205 may be 1350. So please chime in if you know what these are.
__________________
1982 Cherokee
258 cid/T-5 $15 Sunpro Voltmeter gauge
replacement; Quadratec Trailmax Thermal Pro
Seats! 4 inch SKYJACKER suspension lift, 33X12.5 in
BFG Mud Terrain Tires on 15X10 in ProComp Rims.
New BJ's chrome-moly rear axle shafts, 3.73:1 diffs and ARB Air Locker!
Reply With Quote