View Single Post
  #14  
Old 04-01-2022, 08:29 PM
Warlordsix Warlordsix is offline
230 Tornado
 
Join Date: Dec 23, 2021
Location: SE USA
Posts: 21
I now have the GW body off the chassis, the tranny and transfer case out, fuel tank out, and exhaust etc. off on my project. Am stripping and refinishing the frame and suspension and axles. Will next clean up the engine and replace all accessories, ignition, carb/intake, etc. Have accumulated the bellhousing, throwout arm, external slave and lines and master, flywheel and pilot bushing needed to swap on the AX15 and NP231. After that I will move the motor mounts back 6" or so and then drop the YJ body onto the frame to begin mocking everything in. I will start a dedicated build thread, complete with plenty of photos, in the near future. Threepiece, I hope you soon get started on something similar with your chassis, too.

All the best.

Ernie
Reply With Quote