View Single Post
  #17  
Old 06-14-2022, 02:37 PM
PlumCrazyChris PlumCrazyChris is offline
258 I6
 
Join Date: Jun 03, 2002
Location: Round Rock, Texas
Posts: 380
Quote:
Originally Posted by Warlordsix
I'm right in the middle of an AX15 swap now. I'm also simultaneously doing a million other things to this project, too (will start a build thread later), so the AX15 part is not finished. Nevertheless, my recommendation is to use a '94 or later AX15, as that will have an external slave cylinder...much handier. Also, be sure to get the proper pilot bearing. I'm using a National Bearing FC-69907 bearing, which is an actual bearing as opposed to a bushing as used on the earlier CJs. Cost me about $15. I'm also using the 4.0 flywheel and will have it match balanced with the AMC 360 flexplate. Hendrick Motorsport is nearby, and they charge $75 to do that. As to the transfer case, I'm using the NP231 that is currently mounted to the AX15, although I will be installing a slip yoke eliminator on it.

Ernie

Thats really good info Ernie, thanks!

Is the AX15 a Drivers side transfer case, or is it a passenger side like my T18? Can you just re-clock the transfer case so that it is a passenger side drop?
__________________
PlumCrazyChris
Round Rock, TX
1979 Cherokee Chief 360/T18
1990 Grand Wagoneer - sold
1983 Cherokee Laredo Limited - sold, and want it back!
1979 Cherokee Chief - sold
1976 Cherokee Chief - sold
Reply With Quote