International Full Size Jeep Association
Home Forums Reader's Rigs Tech Library Trail Stories FSJ-List
International Full Size Jeep Association  

Go Back   International Full Size Jeep Association > Search Forums

Showing results 1 to 25 of 500
Search took 0.08 seconds.
Search: Posts Made By: tgreese
Forum: General FSJ Tech 11-28-2022, 05:19 PM
Replies: 3
Views: 75
Posted By tgreese
What does the '88 TSM say? The '89 TSM covers it...

What does the '88 TSM say? The '89 TSM covers it under choke adjustment; probably the same.
Forum: General FSJ Tech 11-18-2022, 12:44 PM
Replies: 8
Views: 275
Posted By tgreese
Should not matter as long as the proper signals...

Should not matter as long as the proper signals (manifold vacuum, ported vacuum) are connected to the devices that need them. Some have check valves or delay valves inline that change the signal. For...
Forum: General FSJ Tech 11-15-2022, 12:45 PM
Replies: 8
Views: 275
Posted By tgreese
The diverter valve was sometimes called the...

The diverter valve was sometimes called the anti-backfire valve or burp valve, back in the day. From your description, it seems the check valves will admit air on deccelleration. Or maybe your check...
Forum: General FSJ Discussion 11-15-2022, 12:33 PM
Replies: 3
Views: 191
Posted By tgreese
Same here. The spring on the clutch fork only...

Same here. The spring on the clutch fork only serves to keep the rod tip in the pocket on the fork, as I understand it.
Forum: General FSJ Discussion 11-15-2022, 10:40 AM
Replies: 32
Views: 3,418
Posted By tgreese
Mmm. Maybe on Martha's Vineyard. :confused: I...

Mmm. Maybe on Martha's Vineyard. :confused:

I saw a couple of them in the pick-and-pull on Treble Cove in Billerica MA. Been a few years though.
Forum: General FSJ Tech 11-09-2022, 10:28 AM
Replies: 16
Views: 921
Posted By tgreese
Normally the power valve has a gasket between it...

Normally the power valve has a gasket between it and the carb body, and the cover has a gasket. Not sure where you'd put an o-ring.

I've had good luck with these power valves -...
Forum: General FSJ Tech 11-08-2022, 07:11 PM
Replies: 3
Views: 218
Posted By tgreese
Single-stage acrylic enamel.

Single-stage acrylic enamel.
Forum: General FSJ Tech 10-31-2022, 11:24 AM
Replies: 6
Views: 578
Posted By tgreese
Compare to what came off. The pin needs to be the...

Compare to what came off. The pin needs to be the proper distance from the spring mounts for the springs to fit. Note they could be turned around, front to back. The pin isn't necessarily centered...
Forum: General FSJ Discussion 10-31-2022, 10:15 AM
Replies: 28
Views: 4,028
Posted By tgreese
Kinda sorta suspect this sort of business...

Kinda sorta suspect this sort of business devolution/failure is not limited to Jeep parts. You could imagine similar businesses that start out from somebody's hobby and serve a limited audience of...
Forum: General FSJ Tech 10-31-2022, 10:02 AM
Replies: 10
Views: 470
Posted By tgreese
Typically you set the idle mixture to "best...

Typically you set the idle mixture to "best lean idle." Make sure both screws are the same, and then turn them both in 1/4 turn at a time. In is lean, out is rich. If nothing else is broken (ie power...
Forum: General FSJ Tech 10-31-2022, 09:54 AM
Replies: 16
Views: 921
Posted By tgreese
A couple of comments. You can put the...

A couple of comments.

You can put the distributor rotation anywhere you want, as long as you can set the timing and the firing order is correct. The rotor has to point at #1 wire terminal when the...
Forum: General FSJ Tech 10-28-2022, 11:27 AM
Replies: 16
Views: 921
Posted By tgreese
The usual way sets the engine to #1 TDC before...

The usual way sets the engine to #1 TDC before you take the distributor out. This is easy on a running engine, since the rotor will be pointing to the #1 wire on the compression stroke. Then when you...
Forum: General Chit-Chat 10-27-2022, 12:33 PM
Replies: 10
Views: 754
Posted By tgreese
Nah, I'm sure the tugs are NP208 locked in low...

Nah, I'm sure the tugs are NP208 locked in low with rear wheel drive only. The Dana 20 was long gone by then.

There were quite a few sold in Australia, as I recall....
Forum: General FSJ Tech 10-27-2022, 09:38 AM
Replies: 16
Views: 921
Posted By tgreese
Still too small. Suggest you trace back and...

Still too small.

Suggest you trace back and compare to the wiring diagram. The factory diagram should have the circuits in both table (with colors and wire size) and diagram form.

Turn the engine...
Forum: General FSJ Tech 10-27-2022, 09:33 AM
Replies: 6
Views: 267
Posted By tgreese
The site will not host your pics. Apparently the...

The site will not host your pics. Apparently the ancient forum software does not have an option for "no imbedding" so the owner set the allowed file size to tiny. It's a feature.

Store your pics...
Forum: General FSJ Tech 10-27-2022, 09:27 AM
Replies: 8
Views: 448
Posted By tgreese
I expect it does not matter. If the diagram or...

I expect it does not matter. If the diagram or the TSM does not make a point of it, connect it the easiest way. It's just a switch, not polar.
Forum: General FSJ Tech 10-25-2022, 04:06 PM
Replies: 8
Views: 448
Posted By tgreese
EGR...

EGR TVS:


https://www.nmr.mgh.harvard.edu/~reese/public_html/EGR_TVS.jpg


TAC TVS:
Forum: General FSJ Tech 10-25-2022, 03:32 PM
Replies: 8
Views: 448
Posted By tgreese
Never mind my previous. EGR TVS (thermal vacuum...

Never mind my previous.


EGR TVS (thermal vacuum switch) - shown here.


https://oljeep.com/gw/vac/88vacuum.jpg
Forum: General FSJ Tech 10-20-2022, 02:40 PM
Replies: 6
Views: 451
Posted By tgreese
HELP! is a Dorman brand. I'd get the assortment...

HELP! is a Dorman brand.

I'd get the assortment and use whichever seems to work best.

https://www.dormanproducts.com/p-28324-59207.aspx
Forum: General FSJ Tech 10-19-2022, 11:01 AM
Replies: 4
Views: 284
Posted By tgreese
Not sure what your budget is, but if you search...

Not sure what your budget is, but if you search at car-part.com you will find a few original steel ones for sale. This is a listing site for commercial junkyards. Or try the fs/wtb discussions here.
Forum: General FSJ Tech 10-18-2022, 10:20 AM
Replies: 8
Views: 777
Posted By tgreese
It's not a service part. Does not appear in the...

It's not a service part. Does not appear in the parts manual, which makes it part of the distributor body. You could argue that the rebuilders are ruining these distributors by removing and...
Forum: General FSJ Tech 10-17-2022, 05:41 AM
Replies: 8
Views: 777
Posted By tgreese
The Motorcraft V8 distributors have a tab on the...

The Motorcraft V8 distributors have a tab on the distributor body that keeps the cap from moving. This is held with a screw. If the tab is missing, the cap will fit but it will be able to rotate a...
Forum: Fuel Injection 10-08-2022, 03:08 PM
Replies: 8
Views: 1,255
Posted By tgreese
I think the main appeal of the Rochester TBI is...

I think the main appeal of the Rochester TBI is parts and service. It's all GM/Chevrolet, and any issues away from home can be fixed by most any mechanic, or by you with parts-store parts. The Holley...
Forum: Fuel Injection 10-08-2022, 02:57 PM
Replies: 5
Views: 513
Posted By tgreese
:thumbsup: No like button here, but it deserves...

:thumbsup: No like button here, but it deserves recognition. Both interesting and informative.
Forum: General FSJ Tech 10-08-2022, 02:47 PM
Replies: 4
Views: 649
Posted By tgreese
I have found that the accelerator pump diaphragms...

I have found that the accelerator pump diaphragms on these carbs do not last very long. Maybe it's modern fuels, or decline in quality? You can buy just the pump diaphragm and replace it without...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -6. The time now is 05:16 PM.


Powered by vBulletin Version 3.5.4
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.
corner corner