A couple of quick questions for the Quadratrac experts.
1) What size is the nut on the front and rear output yokes? I have 1/2" impact sockets and 3/4" el cheap socket set. Both of them have side walls too big to fit in the yoke. It looks like the nut is 1 1/8" but I was someone could confirm before I go off and buy a $10 deep well from Sears.
2) Will the front yoke fit on the rear output shaft? My 5" of lift is requiring a double cardan drive shaft on the rear which I have left over from my Dana 20 swap. I need to have the shaft shortened by approximately 4" and before I spend the money on mod, I wanted to make sure I could pull the front yoke from a spare quadratrac and put it on the rear. This way I will run double cardan shafts on front and rear.
1) What size is the nut on the front and rear output yokes? I have 1/2" impact sockets and 3/4" el cheap socket set. Both of them have side walls too big to fit in the yoke. It looks like the nut is 1 1/8" but I was someone could confirm before I go off and buy a $10 deep well from Sears.
2) Will the front yoke fit on the rear output shaft? My 5" of lift is requiring a double cardan drive shaft on the rear which I have left over from my Dana 20 swap. I need to have the shaft shortened by approximately 4" and before I spend the money on mod, I wanted to make sure I could pull the front yoke from a spare quadratrac and put it on the rear. This way I will run double cardan shafts on front and rear.
Comment