Rear frame prepped, epoxy primed and painted (Eastwood chassis black). Inspected the Eldorado rear disk brakes that I retrofitted to the AMC-20 ten years ago...plenty of pad material remaining. Notice the steel plate welded om the top of the frame....a threaded hole in the middle accepts a ball for goose neck trailers.
Tomorrow I'm going to spray the cab/doors with Eastwood After Blast, which is a metal cleaner with a mild phosphoric acid. I used it on other blasted parts and it does a nice job of fending off flash rust. That will give me some breathing room to skim coat and block the old bondo areas before sealing it up with new epoxy and then applying the urethane primer.
, on FlickrDSCN1413
, on Flickr
J10 - Body channel (3 inch drop @ front); dechromed; shaved side parking lights, antenna, and hood trim bar. Ford mirrors, roll pans, side exhaust, 16 inch wheels, custom dash, new interior, Edelbrocked 360, HEI, T18/208 (J20), rear disk brakes, goose neck and bumper hitches.
Last edited by Towtruck : 02-13-2019 at 05:39 PM.