International Full Size Jeep Association
Home Forums Reader's Rigs Tech Library Trail Stories FSJ-List
International Full Size Jeep Association  

Go Back   International Full Size Jeep Association > Search Forums

Showing results 1 to 25 of 500
Search took 0.42 seconds.
Search: Posts Made By: babywag
Forum: Fuel Injection 04-16-2021, 03:40 PM
Replies: 5
Views: 98
Posted By babywag
never experienced one myself... how is it...

never experienced one myself...
how is it mounted?
rubber isolators? used on bolts and bracket around pump?

the one i used on my 90 was for 90's ford mpfi engines and very quiet.
was mounted on...
Forum: General FSJ Discussion 04-14-2021, 08:23 PM
Replies: 5
Views: 89
Posted By babywag
74-77 Not a lot if them got it...

74-77
Not a lot if them got it...
Forum: General FSJ Tech 04-13-2021, 11:34 AM
Replies: 22
Views: 531
Posted By babywag
If you cannot get a repair to hold on the aged...

If you cannot get a repair to hold on the aged plastic?
Originally they were a Ford part...
Check this post for part numbers to cross reference and maybe you can find one over...
Forum: Build Threads 04-13-2021, 11:01 AM
Replies: 36
Views: 4,287
Posted By babywag
As usual got delayed...ran into a couple snags. -...

As usual got delayed...ran into a couple snags.
- Older HD J20 shackles wouldn't fit in the ranger hangers.
- Ranger hangers need 3" wide bushings. Chevy C10 bushings are correct 3" width for...
Forum: Fuel Injection 04-13-2021, 07:41 AM
Replies: 3
Views: 125
Posted By babywag
12* should be fine... timing should not alter...

12* should be fine...
timing should not alter idle speed as it(idle speed) is computer controlled.
whatever howell uses in .bin should be the idle speed.
maybe there is a problem with iac or their...
Forum: General FSJ Discussion 04-08-2021, 07:16 PM
Replies: 8
Views: 209
Posted By babywag
try parts manual on oljeep.com...

try parts manual on oljeep.com yet?

https://www.lov2xlr8.no/brochures/jeep/70jgl/bilder/4.jpg
Forum: General FSJ Discussion 04-08-2021, 10:26 AM
Replies: 10
Views: 171
Posted By babywag
Yes late models Jeep will give you one, however...

Yes late models Jeep will give you one, however they have many errors.
According to Jeep my 90 had these super rare options

CACP Low Back Bucket Seats
DGHS 4-Spd. Automatic 36RH Transmission
EUA...
Forum: General FSJ Discussion 04-07-2021, 01:50 PM
Replies: 10
Views: 171
Posted By babywag
Nope...firewall VIN plate is it. Owned a ton of...

Nope...firewall VIN plate is it.
Owned a ton of these never found/seen a build sheet hidden in any of them.

There are codes of the firewall VIN plate and some info on them in service manual.

The...
Forum: General FSJ Tech 04-07-2021, 10:05 AM
Replies: 22
Views: 531
Posted By babywag
What is your normal fuel blend over there? Any...

What is your normal fuel blend over there?
Any chance of trying a tank of real gas w/o ethanol?

If stock air cleaner still being used? is the inner flap operating correctly?
If it were to be stuck...
Forum: General FSJ Tech 04-06-2021, 10:36 AM
Replies: 46
Views: 1,059
Posted By babywag
x2

x2
Forum: General FSJ Tech 04-03-2021, 02:50 PM
Replies: 11
Views: 223
Posted By babywag
If it is running across firewall to passenger...

If it is running across firewall to passenger side it wasn't the module section.
Module is mounted on driver's side closer to fuseblock on fender liner.

That particular wire has splices.
However if...
Forum: General FSJ Tech 04-02-2021, 10:07 AM
Replies: 22
Views: 531
Posted By babywag
After it heat soaks for a while... Pull air...

After it heat soaks for a while...
Pull air cleaner, open throttle, watch for accel pump shot.
Is it good/strong spray?
While throttle is open look @bottom of intake floor, is there a puddle of fuel...
Forum: General FSJ Tech 04-02-2021, 09:25 AM
Replies: 11
Views: 223
Posted By babywag
Going from memory... I'll say it originally ran...

Going from memory...
I'll say it originally ran to the oil pressure switch down on the "t" that the OP sender is also mounted in.
Forum: General FSJ Tech 03-28-2021, 08:42 AM
Replies: 46
Views: 1,059
Posted By babywag
I say pull axle, easier than doing it in...

I say pull axle, easier than doing it in vehicle!

When I did my 10bolt in Caprice didn't have/use a press.
But it would be easier with one or to have a shop pull the bearings.
I used a cheap bearing...
Forum: General FSJ Tech 03-27-2021, 02:23 PM
Replies: 15
Views: 395
Posted By babywag
location and cost likely... parts scarce and...

location and cost likely...
parts scarce and shipping is $$$$ across pond
Forum: General FSJ Tech 03-26-2021, 01:23 PM
Replies: 11
Views: 313
Posted By babywag
probably a quicker ratio steering gearbox...

probably a quicker ratio steering gearbox installed by a PO.
get a stock 78 box and it'll return to more what you desire.
personally i prefer them vs. the stockers.
Forum: General FSJ Tech 03-26-2021, 09:44 AM
Replies: 13
Views: 353
Posted By babywag
Couple things... The radio supressor dealio(or a...

Couple things...

The radio supressor dealio(or a jumper wire) is needed for the gauges to work. Without it the coolant gauge/CVR doesn't receive ignition power.

The stock gauges depend on a...
Forum: General FSJ Tech 03-25-2021, 01:30 PM
Replies: 15
Views: 395
Posted By babywag
space is tight and as stated might be difficult...

space is tight and as stated might be difficult to get a clean/good solder joint.
be way easier/faster to just drill a small pilot hole and run a small self tapping screw and use a ring terminal.
it...
Forum: General FSJ Tech 03-24-2021, 09:51 AM
Replies: 12
Views: 455
Posted By babywag
I would say it's working normally. You stated...

I would say it's working normally.
You stated 17yrs...in your original post.
With a 195 tsat it'll run 200-210...only an issue if it gets to 220 or higher consistently.
Forum: General FSJ Tech 03-20-2021, 04:43 PM
Replies: 5
Views: 293
Posted By babywag
Yes ignition coil...stock the come with horseshoe...

Yes ignition coil...stock the come with horseshoe shaped plastic connector that slides onto top of coil & posts.
It is a known problem area.

The engine "twists" on mounts opposite direction in...
Forum: General FSJ Tech 03-20-2021, 11:49 AM
Replies: 5
Views: 293
Posted By babywag
With engine idling spray brake cleaner or similar...

With engine idling spray brake cleaner or similar around all vacuum fitings/hoses/base of throttle body/etc. any change in rpm and you've found a leak.

no reason not to disconnect cruise if it's...
Forum: General FSJ Tech 03-18-2021, 09:58 AM
Replies: 11
Views: 1,224
Posted By babywag
Hellcreek posted a good resource for bushings, it...

Hellcreek posted a good resource for bushings, it includes sizes & PN's

http://www.ifsja.org/forums/vb/showthread.php?t=74766
Forum: General Chit-Chat 03-18-2021, 08:56 AM
Replies: 10
Views: 498
Posted By babywag
that's not "fixing stupid", just the...

that's not "fixing stupid", just the carnage caused by stupid.
The stupid is still there waiting for it's next chance :lol: :lol:
Forum: General FSJ Tech 03-18-2021, 08:51 AM
Replies: 16
Views: 488
Posted By babywag
I wonder what the jetting is on the new carb? If...

I wonder what the jetting is on the new carb?

If it's a small venturi version and has smaller main jets than ideal?
Undersized jets and I could see a lean stumble occuring.
Forum: General FSJ Tech 03-17-2021, 05:42 PM
Replies: 16
Views: 488
Posted By babywag
define "new"...a china repop or a...

define "new"...a china repop or a reman?
just because a part is new doesn't mean it can't be bad.

did this just start happening or was it doing it already prior to new carb
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -6. The time now is 07:47 AM.


Powered by vBulletin Version 3.5.4
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.
corner corner