International Full Size Jeep Association
Home Forums Reader's Rigs Tech Library Trail Stories FSJ-List
International Full Size Jeep Association  

Go Back   International Full Size Jeep Association > Search Forums

Showing results 1 to 25 of 500
Search took 0.04 seconds.
Search: Posts Made By: wiley-moeracing
Forum: General FSJ Discussion 01-20-2020, 01:00 PM
Replies: 10
Views: 230
Posted By wiley-moeracing
You will not break even on the engine swap, you...

You will not break even on the engine swap, you could get a 5.3 for free and still not break even. By the time you figure in the computers, wiring harness programing, fuel system, mounts exhaust and...
Forum: General FSJ Tech 01-13-2020, 10:19 AM
Replies: 51
Views: 829
Posted By wiley-moeracing
That will be a 78' most likely and the fuse panel...

That will be a 78' most likely and the fuse panel would be correct. you can clean up the fuse block and purchase the correct fuses for it and it will be good or change out to the later style with the...
Forum: General FSJ Tech 01-12-2020, 07:01 AM
Replies: 51
Views: 829
Posted By wiley-moeracing
That is the correct fuse panel for the truck, as...

That is the correct fuse panel for the truck, as far as the green part, not factory( looks real scary) but is some sort of resistor? What do the wires go to? You need to repair or replace the set up...
Forum: General FSJ Tech 01-11-2020, 07:17 AM
Replies: 51
Views: 829
Posted By wiley-moeracing
Love the modified fuses! at least its better than...

Love the modified fuses! at least its better than the .22 bullets I have seen used!
Forum: Wanted 01-10-2020, 06:07 PM
Replies: 4
Views: 95
Posted By wiley-moeracing
Did you try napa auto parts? They are available,...

Did you try napa auto parts? They are available, also try rock auto.
Forum: General FSJ Tech 01-10-2020, 05:55 PM
Replies: 29
Views: 842
Posted By wiley-moeracing
Good to hear! Sometimes its a little thing that...

Good to hear! Sometimes its a little thing that gets missed.
Forum: General FSJ Tech 01-10-2020, 09:46 AM
Replies: 29
Views: 842
Posted By wiley-moeracing
You still should be better than 20 seconds to hit...

You still should be better than 20 seconds to hit 60? are you getting full throttle on the tbi? Hell a loaded 18 wheeler will do that! 120 psi is a little low but will run ok, you may need to find a...
Forum: General FSJ Tech 01-10-2020, 06:33 AM
Replies: 29
Views: 842
Posted By wiley-moeracing
Compression at 220 per cylinder? more like 120...

Compression at 220 per cylinder? more like 120 maybe?
Forum: General FSJ Discussion 12-29-2019, 07:28 AM
Replies: 6
Views: 216
Posted By wiley-moeracing
Not if the pump is shot.

Not if the pump is shot.
Forum: General FSJ Tech 12-28-2019, 07:31 AM
Replies: 29
Views: 842
Posted By wiley-moeracing
Replacing the torque convertor with a high stall...

Replacing the torque convertor with a high stall one will not get you more "performance" over a gear swap. It only raises the rpm lock up level to put you higher in the power curve of your motor,...
Forum: General FSJ Tech 12-26-2019, 12:31 AM
Replies: 77
Views: 3,960
Posted By wiley-moeracing
Lets hope the shift shaft seal does not leak....

Lets hope the shift shaft seal does not leak....
Forum: General FSJ Tech 12-16-2019, 04:53 AM
Replies: 33
Views: 1,372
Posted By wiley-moeracing
The ecu was an emission unit normally on...

The ecu was an emission unit normally on California vehicle models, not until later usually. Maybe a universal wiring diagram and not specific to your truck is what your looking at?
Forum: General FSJ Tech 12-15-2019, 03:08 AM
Replies: 29
Views: 842
Posted By wiley-moeracing
You seem to have an issue or issues, it should...

You seem to have an issue or issues, it should not take that long to accelerate to 60. I used to drag race against a olds diesel wagon that would do the 1/4 mile in 18.6 seconds at 83 miles mph bone...
Forum: General FSJ Tech 12-12-2019, 04:47 AM
Replies: 14
Views: 418
Posted By wiley-moeracing
Or purchase the matching filler neck assembly for...

Or purchase the matching filler neck assembly for the newer tank and install in your vehicle.
Forum: General FSJ Tech 12-12-2019, 04:44 AM
Replies: 8
Views: 309
Posted By wiley-moeracing
Fix the leak and not with stop leak, they do not...

Fix the leak and not with stop leak, they do not work.
Forum: General FSJ Tech 12-12-2019, 04:43 AM
Replies: 13
Views: 764
Posted By wiley-moeracing
I think all he is saying is don't waste your time...

I think all he is saying is don't waste your time sand money on this modification, not needed unless your turning this motor at high rpms for long durations.( which is what I said also)
Forum: General FSJ Tech 12-06-2019, 07:50 AM
Replies: 29
Views: 842
Posted By wiley-moeracing
The most I would go is the 3:73, acceleration...

The most I would go is the 3:73, acceleration will be better but sacrifice a little on the top end speed( will do it but at a higher rpm). 3:55 if your more worried about top speed.
Forum: General FSJ Tech 12-02-2019, 04:30 AM
Replies: 13
Views: 764
Posted By wiley-moeracing
Don't need to do the oil line modification for...

Don't need to do the oil line modification for your stock rebuild, save the money.
Forum: Build Threads 11-11-2019, 10:26 AM
Replies: 121
Views: 9,616
Posted By wiley-moeracing
Just leave the vacuum pump on the system for...

Just leave the vacuum pump on the system for 30-60 minutes, this will pull all the moisture out of the system.
Forum: General FSJ Tech 11-11-2019, 10:22 AM
Replies: 3
Views: 183
Posted By wiley-moeracing
I would stick with a 12" convertor with a...

I would stick with a 12" convertor with a slightly higher stall speed, will have higher fluid capacity for cooler running and be better for street driving. I have used Hughes convertors with good...
Forum: Online Sale Links: (Ebay, Craigslist, etc.) 11-11-2019, 01:01 AM
Replies: 3
Views: 306
Posted By wiley-moeracing
I think its a steal, no rust, az truck! Your...

I think its a steal, no rust, az truck! Your living in the past if you think that's to much money.
Forum: General FSJ Tech 11-09-2019, 02:19 PM
Replies: 9
Views: 330
Posted By wiley-moeracing
Did you install the new ignition switch...

Did you install the new ignition switch correctly( pull the plastic pin before install?) and not get it aligned correctly?
Forum: General FSJ Discussion 11-09-2019, 02:17 PM
Replies: 61
Views: 4,037
Posted By wiley-moeracing
You will have to change the oil and flush the...

You will have to change the oil and flush the system then fill compressor with the correct oil for r134. You can check the factory service manual for capacities or check online but that's just a...
Forum: General FSJ Tech 11-05-2019, 04:19 AM
Replies: 11
Views: 337
Posted By wiley-moeracing
Holley red fuel pump( there rebuildable too), and...

Holley red fuel pump( there rebuildable too), and add a fuel pressure regulator just to make sure you do not flood the carb floats with to much pressure.
Forum: Wanted 10-29-2019, 04:44 AM
Replies: 4
Views: 337
Posted By wiley-moeracing
vintage jeep air, I believe they sell the vent...

vintage jeep air, I believe they sell the vent assembly's.
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -6. The time now is 12:15 AM.


Powered by vBulletin Version 3.5.4
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
corner corner