International Full Size Jeep Association
Home Forums Reader's Rigs Tech Library Trail Stories FSJ-List
International Full Size Jeep Association  

Go Back   International Full Size Jeep Association > Search Forums

Showing results 1 to 25 of 500
Search took 0.44 seconds.
Search: Posts Made By: Crazy_Jeepman
Forum: Street & Performance 12-11-2016, 08:09 AM
Replies: 14
Views: 2,560
Posted By Crazy_Jeepman
I am looking but I don't see it!..........I know...

I am looking but I don't see it!..........I know there's a HOLE in that garage!
Forum: General FSJ Tech 09-02-2011, 06:16 AM
Replies: 13
Views: 1,408
Posted By Crazy_Jeepman
You will never get the split threaded insert out...

You will never get the split threaded insert out without the balljoint removed. http://i556.photobucket.com/albums/ss8/bad_37_nash/balljoint.jpg

Where the arrows are you want to hit HARD with a BIG...
Forum: General FSJ Tech 02-13-2011, 08:54 AM
Replies: 2
Views: 826
Posted By Crazy_Jeepman
Well the motor will fit, with some minor...

Well the motor will fit, with some minor differances. This question was just asked a few days ago, answers can be found here, years are not exact, but it still applies...
Forum: General FSJ Tech 02-13-2011, 08:48 AM
Replies: 11
Views: 862
Posted By Crazy_Jeepman
Coulple Gulps of coffee and re-read your thread,...

Coulple Gulps of coffee and re-read your thread, I realize it was the T-Case that was in Neutral and trans in gear?? If so, then yes the problem lies there. Could be as simple as low on oil, to...
Forum: General FSJ Tech 02-13-2011, 08:37 AM
Replies: 11
Views: 862
Posted By Crazy_Jeepman
I can't be sure what the problem is, however I...

I can't be sure what the problem is, however I can tell you it won't be the T-Case. Parked at idle nothing in the T-case is moving. I would be looking at the Transmission first. The T5 is a weak...
Forum: General FSJ Discussion 02-08-2011, 11:45 PM
Replies: 37
Views: 4,132
Posted By Crazy_Jeepman
I had a set of 92 CTD Dodge D60 axles under my 83...

I had a set of 92 CTD Dodge D60 axles under my 83 Cherokee, it was pretty much a bolt in deal. Spring pads and width was just fine.
Forum: General FSJ Discussion 02-08-2011, 11:36 PM
Replies: 3
Views: 769
Posted By Crazy_Jeepman
79 wil have 360 GM th400 trans Q-trac...

79 wil have 360 GM th400 trans Q-trac transfercase, and pass drop front axle rear pumpkin offset to pass side. 88 will have 360 Mopar TF727 trans np229 transfercase, drivers drop front axle, centered...
Forum: General FSJ Tech 02-08-2011, 11:17 PM
Replies: 15
Views: 3,981
Posted By Crazy_Jeepman
Yea they just fit in there loose, sometimes (most...

Yea they just fit in there loose, sometimes (most of the time) they can be difficult to remove do to varnish and other contaminent buildup. If you get new bearings, chances are you are going to get...
Forum: General FSJ Discussion 02-08-2011, 09:00 AM
Replies: 4
Views: 813
Posted By Crazy_Jeepman
http://i246.photobucket.com/albums/gg107/jeep_albu...

http://i246.photobucket.com/albums/gg107/jeep_albums/Picture284.jpg
Forum: General FSJ Discussion 02-02-2011, 01:04 PM
Replies: 13
Views: 1,212
Posted By Crazy_Jeepman
those rivets are soft. I have removed them with a...

those rivets are soft. I have removed them with a good chisel, or jost grind the heads off and punch them through. What is going to be fun, is putting it back on, I beleive the frame is boxed at that...
Forum: General FSJ Tech 02-01-2011, 02:59 PM
Replies: 11
Views: 2,769
Posted By Crazy_Jeepman
Warn Hubs will not honour warranty if hubs are...

Warn Hubs will not honour warranty if hubs are greased, they come packed with enough from the factory. To much grease will cause the hubs locking ability to hang up, and not be fully engaged, then...
Forum: General FSJ Tech 01-25-2011, 11:06 AM
Replies: 8
Views: 973
Posted By Crazy_Jeepman
Does the noise or the pitch of the noise change...

Does the noise or the pitch of the noise change when rounding a corner or turns? If so I would be looking at Wheel Bearings being the problem. They are pretty straight forward to change, no special...
Forum: General FSJ Discussion 01-25-2011, 10:04 AM
Replies: 1
Views: 501
Posted By Crazy_Jeepman
You would have to have them either recentered or...

You would have to have them either recentered or run spacers to put them on, they are 9" wide and have a7" BS. I had the 12 bolt version and went with them because rumor has it the 8 bolt version was...
Forum: General FSJ Discussion 01-24-2011, 04:58 PM
Replies: 20
Views: 3,409
Posted By Crazy_Jeepman
My 69 & 70 Wagoneer had the bag, however the...

My 69 & 70 Wagoneer had the bag, however the pump was within the Windshield Wiper motor. I want to say it had the bag with the aluminum cap on it.
Forum: General FSJ Tech 01-23-2011, 08:31 PM
Replies: 6
Views: 984
Posted By Crazy_Jeepman
Why do you want a Dodge T-Case if you plan on...

Why do you want a Dodge T-Case if you plan on running a 700R4? Just get a 700R4 mated to a NP208 out of a Chevy and you are done. Tad did his setup, but it was a major pain in the butt due to...
Forum: General FSJ Discussion 01-23-2011, 05:58 PM
Replies: 63
Views: 2,172
Posted By Crazy_Jeepman
Install 4 of these, and Car Pool with some Big...

Install 4 of these, and Car Pool with some Big Guys

http://i556.photobucket.com/albums/ss8/bad_37_nash/GREATMPG.jpg
Forum: General FSJ Discussion 01-23-2011, 05:10 PM
Replies: 63
Views: 2,172
Posted By Crazy_Jeepman
What kind of MPG are you looking for? This Combo...

What kind of MPG are you looking for? This Combo is not going to get you anything Fantastic at the very least. Time, Parts, maybe it runs good maybe it don't still = two tons of scrap iron going down...
Forum: General FSJ Discussion 01-23-2011, 02:18 PM
Replies: 16
Views: 3,363
Posted By Crazy_Jeepman
It is an airplane shotgun starter, put the...

It is an airplane shotgun starter, put the cartridge in it, ignition ON and fire the thing, it would spin the motor over!! and....................... Maybe start :eek: I always...
Forum: General FSJ Discussion 01-23-2011, 02:06 PM
Replies: 16
Views: 3,363
Posted By Crazy_Jeepman
I always thought this would be fun to fire up in...

I always thought this would be fun to fire up in a Busy Wal-Mart Parking lot!!! :thumbsup:...
Forum: General FSJ Tech 01-23-2011, 01:20 PM
Replies: 18
Views: 1,661
Posted By Crazy_Jeepman
OK I give up...............Stick it in the Gas...

OK I give up...............Stick it in the Gas Tank and be done with it :p



Here is a quote from the Orange ($8.95) GM...
Forum: General FSJ Tech 01-23-2011, 01:02 PM
Replies: 18
Views: 1,661
Posted By Crazy_Jeepman
Well B&M says different so does a couple...

Well B&M says different so does a couple other sources:confused: :confused:
Here is Step #2 from B&M
STEP 2. Locate the oil return line to the transmission. On
Chrysler and most Ford transmissions,...
Forum: General FSJ Tech 01-23-2011, 12:54 PM
Replies: 18
Views: 1,661
Posted By Crazy_Jeepman
Why would you want to know the temp of the COOLED...

Why would you want to know the temp of the COOLED Trans Fluid? It would be far to late to find out your trans is overheating by then.
If you think about it, the engine temp sensor is located just...
Forum: General FSJ Tech 01-23-2011, 12:29 PM
Replies: 5
Views: 609
Posted By Crazy_Jeepman
Yes, remove the bolt and with some coaxing it...

Yes, remove the bolt and with some coaxing it will come off. If I remember correctly there are lock tabs to contend with as well.
Forum: General FSJ Tech 01-22-2011, 07:32 PM
Replies: 16
Views: 1,208
Posted By Crazy_Jeepman
I would check for Vacuum at the modulator again,...

I would check for Vacuum at the modulator again, be sure it is pulling good Vac. Buy a new modulator try that. Sure sounds like that is the problem.
Forum: General FSJ Tech 01-22-2011, 02:32 PM
Replies: 8
Views: 849
Posted By Crazy_Jeepman
SIGH!!! :huh: Ya all knew what I meant!!...

SIGH!!! :huh: Ya all knew what I meant!! :whistle:
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -6. The time now is 01:33 AM.


Powered by vBulletin Version 3.5.4
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
corner corner