International Full Size Jeep Association
Home Forums Reader's Rigs Tech Library Trail Stories FSJ-List
International Full Size Jeep Association  

Go Back   International Full Size Jeep Association > Search Forums

Showing results 1 to 25 of 500
Search took 0.30 seconds.
Search: Posts Made By: wiley-moeracing
Forum: General FSJ Tech 09-25-2022, 06:53 AM
Replies: 11
Views: 186
Posted By wiley-moeracing
It does look like the alignment for the power...

It does look like the alignment for the power steering belt is off (by the pic), is the pulley pressed on all the way, do you have spacers or washers installed behind the mounting brackets? It looks...
Forum: General FSJ Tech 09-25-2022, 06:48 AM
Replies: 4
Views: 132
Posted By wiley-moeracing
sounds like the switch is shorted ground or the...

sounds like the switch is shorted ground or the wiring to the switch is shorted to ground.
Forum: General FSJ Discussion 09-24-2022, 08:51 AM
Replies: 9
Views: 3,933
Posted By wiley-moeracing
You do know that this post was over 12 years ago?

You do know that this post was over 12 years ago?
Forum: General FSJ Tech 09-21-2022, 04:20 AM
Replies: 31
Views: 22,673
Posted By wiley-moeracing
Bingo!

Bingo!
Forum: Wanted 09-04-2022, 12:06 PM
Replies: 8
Views: 1,577
Posted By wiley-moeracing
Or get some large heat shrink tube for electrical...

Or get some large heat shrink tube for electrical work and install it over the cracked area?
Forum: General FSJ Tech 08-22-2022, 04:28 AM
Replies: 4
Views: 158
Posted By wiley-moeracing
It has been awhile since I had to do repairs on...

It has been awhile since I had to do repairs on these, the bevel should point towards the spindle, match the bevel of the spindle where it will ride.
Forum: General FSJ Tech 07-24-2022, 08:00 AM
Replies: 8
Views: 436
Posted By wiley-moeracing
Unless the vacuum switch is worn out and you are...

Unless the vacuum switch is worn out and you are leaking vacuum through there, then a cable would be better.
Forum: General FSJ Tech 07-22-2022, 10:32 AM
Replies: 5
Views: 294
Posted By wiley-moeracing
You should line up the notch on the dampener with...

You should line up the notch on the dampener with the tdc on the timing cover, then align the distributor rotor to the #1 terminal on the cap by rotating the distributor after loosening the hold down...
Forum: General FSJ Tech 07-16-2022, 01:58 PM
Replies: 10
Views: 464
Posted By wiley-moeracing
Ideally, a different trans with the overdrive in...

Ideally, a different trans with the overdrive in it and a lock up convertor and changing gears in the diff to 373 will make it more enjoyable to drive. Something I may get around to one day.
Forum: General FSJ Tech 07-16-2022, 07:09 AM
Replies: 10
Views: 464
Posted By wiley-moeracing
If you are doing this to save gas, it is not...

If you are doing this to save gas, it is not worth it, that $3200 will buy a lot of gas over the years, not to mention your labor and other parts needed to do the install. You could do a transmission...
Forum: General FSJ Tech 07-15-2022, 09:22 AM
Replies: 16
Views: 404
Posted By wiley-moeracing
Novak may be getting ready to re produce the...

Novak may be getting ready to re produce the ranger overdrive again, you could check into that?
Forum: General FSJ Tech 07-15-2022, 09:20 AM
Replies: 9
Views: 341
Posted By wiley-moeracing
You need a replacement foot pedal assembly for...

You need a replacement foot pedal assembly for the parking brake in the cab, the gears get worn down or the rivet gets sloppy that holds the unit together.
Forum: General FSJ Tech 07-12-2022, 05:36 PM
Replies: 37
Views: 5,059
Posted By wiley-moeracing
I understand, you can also use search to help...

I understand, you can also use search to help locate the info needed?
Forum: General FSJ Tech 07-11-2022, 06:07 PM
Replies: 37
Views: 5,059
Posted By wiley-moeracing
You do realize that this post was from 5 plus...

You do realize that this post was from 5 plus years ago?
Forum: General FSJ Tech 07-03-2022, 01:32 PM
Replies: 4
Views: 213
Posted By wiley-moeracing
I have used anti-seize before on over the road...

I have used anti-seize before on over the road tractor clutches that I knew were running in the salt and sleet for long periods, but it was a very thin film.
Forum: General FSJ Tech 07-03-2022, 07:43 AM
Replies: 4
Views: 213
Posted By wiley-moeracing
You can run the risk of gumming up the splines...

You can run the risk of gumming up the splines with grease or paint or worse, having the grease drip down on the clutch itself.
Forum: General FSJ Tech 07-03-2022, 07:41 AM
Replies: 3
Views: 279
Posted By wiley-moeracing
I think you already answered your own question.

I think you already answered your own question.
Forum: General FSJ Tech 06-20-2022, 08:24 AM
Replies: 29
Views: 957
Posted By wiley-moeracing
You need to pull the carb off and tear down and...

You need to pull the carb off and tear down and inspect the idle circuits, make sure that the idle screws were not tightened down so much that the casting in the base did not break out part of the...
Forum: General FSJ Tech 06-11-2022, 07:27 AM
Replies: 4
Views: 488
Posted By wiley-moeracing
Looking at them, they may be spacers in between...

Looking at them, they may be spacers in between the rollers on a tapered bearing, I remember seeing something like that a long time ago.
Forum: General FSJ Tech 05-23-2022, 04:11 AM
Replies: 29
Views: 957
Posted By wiley-moeracing
The carb needs to be cleaned, blocked passages,...

The carb needs to be cleaned, blocked passages, then look for a vacuum leak. plug off all ports and try again, Do you know your fuel filter is in the correct way and fuel pump is pumping fuel when...
Forum: General FSJ Tech 05-17-2022, 04:29 AM
Replies: 11
Views: 484
Posted By wiley-moeracing
Any oil you can find will work fine, save some...

Any oil you can find will work fine, save some money and go regular oil.
Forum: General FSJ Tech 05-14-2022, 09:08 AM
Replies: 9
Views: 281
Posted By wiley-moeracing
I am a little confused by your post, 1st, are you...

I am a little confused by your post, 1st, are you trying to convert a r12 system to a 134 system? Do not mix the two. Are you sure you have the valves in the correct position, and do you have the...
Forum: Off-Road FSJ Tech 05-07-2022, 06:47 AM
Replies: 7
Views: 801
Posted By wiley-moeracing
Someone had put up my old race chassis for sale...

Someone had put up my old race chassis for sale again, I see it every couple of years, funny the price for it went up 4x what I sold it for. Would like to get my old j-10 chassis back and fix it up,...
Forum: Off-Road FSJ Tech 05-05-2022, 06:51 PM
Replies: 7
Views: 801
Posted By wiley-moeracing
What info are you looking for? I got sidetracked...

What info are you looking for? I got sidetracked reading the article again. I have a j10 sitting here that I am selling but may need to keep it and fix it up, damn jeep bug! I had a very similar j-10...
Forum: Street & Performance 04-23-2022, 07:43 AM
Replies: 5
Views: 1,314
Posted By wiley-moeracing
I thought there is a stand alone controller...

I thought there is a stand alone controller available for that. I don't know how bad you want this set up but it was not cheap.
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -6. The time now is 07:41 AM.


Powered by vBulletin Version 3.5.4
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.
corner corner