International Full Size Jeep Association
Home Forums Reader's Rigs Tech Library Trail Stories FSJ-List
International Full Size Jeep Association  

Go Back   International Full Size Jeep Association > Search Forums

Showing results 1 to 25 of 500
Search took 0.34 seconds.
Search: Posts Made By: wiley-moeracing
Forum: General FSJ Tech Yesterday, 08:20 AM
Replies: 13
Views: 132
Posted By wiley-moeracing
Sounds like your leaking fuel from somewhere,...

Sounds like your leaking fuel from somewhere, check down the carb when running and see if you have a float stuck, or on the quadrajets also will develop leaks at the hole plugs in the carb( which is...
Forum: General FSJ Tech Yesterday, 08:15 AM
Replies: 5
Views: 84
Posted By wiley-moeracing
can also be the rear seal on the intake manifold...

can also be the rear seal on the intake manifold leaking down, and or valve covers, check both.
Forum: General FSJ Discussion 04-01-2020, 04:18 AM
Replies: 6
Views: 118
Posted By wiley-moeracing
those should be vent lines.

those should be vent lines.
Forum: General FSJ Discussion 04-01-2020, 04:17 AM
Replies: 1
Views: 47
Posted By wiley-moeracing
double check that you have the correct ball...

double check that you have the correct ball joints.
Forum: General FSJ Tech 03-30-2020, 04:24 AM
Replies: 3
Views: 105
Posted By wiley-moeracing
Best would be some 3m automotive double sided...

Best would be some 3m automotive double sided tape meant for vehicle use, usually grey with red plastic backing tape.
Forum: General FSJ Tech 03-30-2020, 04:14 AM
Replies: 3
Views: 106
Posted By wiley-moeracing
also check the fusible links by the battery.

also check the fusible links by the battery.
Forum: General FSJ Discussion 03-28-2020, 05:53 AM
Replies: 27
Views: 350
Posted By wiley-moeracing
easiest to look into amc cars with the 304 and...

easiest to look into amc cars with the 304 and 727 trans for the flexplate, maybe early to late 70's?
Forum: General FSJ Discussion 03-24-2020, 11:42 PM
Replies: 8
Views: 239
Posted By wiley-moeracing
Then your going to have your work cut out for...

Then your going to have your work cut out for you, may need the correct header panel replaced that has the welded mounts on them. Will be easier than trying to find the mounts and weld them in the...
Forum: General FSJ Discussion 03-24-2020, 11:39 PM
Replies: 27
Views: 350
Posted By wiley-moeracing
may need the correct flexplate

may need the correct flexplate
Forum: General FSJ Discussion 03-24-2020, 06:32 PM
Replies: 8
Views: 239
Posted By wiley-moeracing
No, just the welded tabs on the bottom of the...

No, just the welded tabs on the bottom of the header panel.
Forum: General FSJ Tech 03-23-2020, 04:32 AM
Replies: 14
Views: 338
Posted By wiley-moeracing
I would give headman a call and talk to them, my...

I would give headman a call and talk to them, my headman's were much better than that and a tiny bit of work made them perfect, I have a set of summit brand and they are better than that on my cj...
Forum: General FSJ Tech 03-22-2020, 12:15 AM
Replies: 14
Views: 338
Posted By wiley-moeracing
Put the exhaust gasket up against the headers and...

Put the exhaust gasket up against the headers and take another pic for us. The headers look like the weld bead around the port is not even and missing in some areas? It looks like they are headman or...
Forum: Street & Performance 03-21-2020, 07:23 PM
Replies: 7
Views: 247
Posted By wiley-moeracing
You should change the cam, go smaller, less...

You should change the cam, go smaller, less duration if you plan on using in your truck. you will really need a good torque cam in there with some midrange to make it work well.
Forum: General FSJ Discussion 03-18-2020, 06:21 PM
Replies: 8
Views: 239
Posted By wiley-moeracing
You will need the headlight buckets or sure,...

You will need the headlight buckets or sure, square vs. round and the correct screws would be helpful.
Forum: General FSJ Discussion 03-13-2020, 01:16 PM
Replies: 11
Views: 751
Posted By wiley-moeracing
It will read that with a discharged battery and ...

It will read that with a discharged battery and or right after cranking till the battery is charged. Was it reading this after a fully charged battery and running for awhile?
Forum: General FSJ Tech 03-08-2020, 06:51 AM
Replies: 4
Views: 219
Posted By wiley-moeracing
Should be ported valve in the intake manifold and...

Should be ported valve in the intake manifold and have a delay valve in line.
Forum: General FSJ Discussion 02-29-2020, 07:37 AM
Replies: 5
Views: 211
Posted By wiley-moeracing
Easy if you have a 2 post lift, if not, you will...

Easy if you have a 2 post lift, if not, you will need some friends. It takes time to disassemble everything to make it light enough to lift off.
Forum: Wanted 02-28-2020, 12:31 PM
Replies: 5
Views: 170
Posted By wiley-moeracing
It looks like it is all there, why not just glue...

It looks like it is all there, why not just glue it back together?
Forum: General FSJ Tech 02-28-2020, 08:22 AM
Replies: 22
Views: 774
Posted By wiley-moeracing
Use anti seize when installing stainless steel.

Use anti seize when installing stainless steel.
Forum: General FSJ Discussion 02-28-2020, 08:15 AM
Replies: 13
Views: 415
Posted By wiley-moeracing
Good one! There are so many vehicles with rear...

Good one! There are so many vehicles with rear mounted fuel tanks that they should have all blown up. That's a bit of sarcasm right there.
Forum: General FSJ Discussion 02-27-2020, 04:20 AM
Replies: 13
Views: 415
Posted By wiley-moeracing
How did you survive and not blow up?

How did you survive and not blow up?
Forum: General Chit-Chat 02-17-2020, 09:33 AM
Replies: 21
Views: 718
Posted By wiley-moeracing
Been on that cruise before, make sure you bring...

Been on that cruise before, make sure you bring enough money ahead of time for tips, booze and extras you will buy onboard and put it away before the ship leaves. If you drink a lot see about alcohol...
Forum: General FSJ Tech 02-16-2020, 11:57 PM
Replies: 9
Views: 850
Posted By wiley-moeracing
From 3 years ago??

From 3 years ago??
Forum: General FSJ Discussion 02-13-2020, 04:21 AM
Replies: 2
Views: 131
Posted By wiley-moeracing
It looks like they are working but may have the...

It looks like they are working but may have the wrong linkage on them(throw is not long enough?), When parked are they in the correct position or are the wipers mounted wrong( install after the motor...
Forum: General FSJ Tech 02-09-2020, 09:04 AM
Replies: 5
Views: 126
Posted By wiley-moeracing
There should be a hole with a rubber grommet on...

There should be a hole with a rubber grommet on the passenger side foot well above the a/c system and above the floor vent.
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -6. The time now is 02:36 PM.


Powered by vBulletin Version 3.5.4
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
corner corner